Radon testing and mitigation in Salt Lake City, Utah

What public data can and cannot tell you about radon in Salt Lake City (Salt Lake County), plus how to test and estimate mitigation cost.

Salt Lake City has a wide mix of housing: older bungalows and basements in the Avenues and central neighborhoods, mid-century west-side homes, and newer infill. The east benches sit closer to the mountains; the west side sits lower on the valley floor. The 2026 State of Radon in Utah report, as covered by KSL, noted higher radon potential on the benches near the mountains and often lower readings on valley floors — and also said radon shows up in every area of Utah. That is a pattern, not a reading for your address.

County data, not a house reading

Here is the public county context for Salt Lake City. Utah IBIS long-term (2017) county averages put Salt Lake County at 2.9 pCi/L, compared with a statewide average of 3.2 pCi/L. Those are county figures, not a reading for your house. The 2026 State of Radon in Utah report found 69.6% of tests above 2.0 pCi/L and about one in three above the EPA action level of 4.0 pCi/L; benches often test higher than valley floors. Look up your ZIP in the Utah DEQ radon ZIP tool and use a test kit. Estimate mitigation cost if you already have a high result.

For the four-county picture, including the IBIS table and the 2026 statewide report, see radon levels in Utah by county.

Estimate mitigation cost

If you already have a high result, the estimator uses published price ranges by foundation type. Then request a quote from a contractor who services Salt Lake County and the rest of the Wasatch Front.

Open the cost estimator Get a radon quote

Working on a driveway or patio at the same address? Use the Salt Lake City concrete calculator.

Concrete tools: calculator, cubic yards, slabs, bags, footings, driveway cost, patio cost.

Common questions

Are radon levels high in Salt Lake City?

There is no substitute for a test in your house. Salt Lake County’s long-term IBIS average is 2.9 pCi/L, compared with a statewide average of 3.2 pCi/L. Utah DEQ says one in three Utah homes test above 4 pCi/L. Look up your ZIP in the DEQ tool and use a kit.

How do I test a home in Salt Lake City?

Utah DEQ sells a short-term kit for about $11 including lab processing. Leave it in the basement or lowest lived-in level for two to four days, then mail it in. Winter, when the house is closed up, is the better season.

How much does mitigation cost in Salt Lake City?

Utah DEQ says mitigation can typically be done for $1,500 or less. A 2026 report covered by KSL quoted about $2,000. Your price depends on the foundation, the pipe route, and how many suction points are needed — use the cost estimator, then get a local quote.

Sources